??48V Battery Fuel Gauge??This device is only workable on lead-acid battery but not Trojian type.LED battery indicator available in 48V volt DC acid battery
??LED Battery Indicator Meter??10 segment LED Bar Graph display,Resolution: 10% per segment??3 color LED display,different light displays different battery level visually;LED flash for low charge&high charge warning
??Note??The second LED from the left flashes as a warning that the batteries voltage has been discharged to 80% of their capacity.It is strongly recommended to recharge the batteries when you get to the 3rd Yellow LED, this is a safety precaution to avoid dead batteries
?? Installation Notes??Make sure your “C” terminal is either connected to the Battery “+” or a Key switch, Meter will scan from full to empty then shuts off .Meter will stay full position while first is connected with batteries and indicate the actual battery level after 155 seconds.
?? Battery Indicator??LED battery indicator battery fuel gauge battery charge gauge for DC powered equipment such as fork lifts, golf carts, floor care equipment, and any other battery powered
Product Description
48V LED Battery Indicator Meter RL-BI003 (Acid lead storage Battery) LED battery indicator battery fuel gauge battery charge gauge for DC powered equipment such as fork lifts, golf carts, floor care equipment, and any other battery powered. This battery indicator is suit for 48V. This battery meter Delay Display Function,Power off Memory Function,Open Circuit Reset Function. Product Specification Product Size: 53x33x24(mm?? Display Screen: 10 Segment LED Bar Graph Operate Current: 20mA Operate Temperature: -30??C- 85??C Pin Type: +,-,C Package: With Box N.W.: 45g Waterproof Rate: IP65 Troubleshooting Tips 1, Meter cannot move to full charge. This happens when battery was fully charged but the battery voltage cannot reach to preset fully charged voltage of meter, just disconnect the meter from power and reconnect, meter will reset to full. 2, Meter scans from full to empty then shuts off: This occurs if your ??C” terminal is not connected, make sure your ??C” terminal is either connected to the battery + or a key switch. Note The second LED from the left flashes as a warning that the batteries voltage has been discharged to 80% of their capacity. At a 90% battery discharge, the red and yellow LEDs will alternately flash to indicate a very low voltage capacity is remining. It is strongly recommended to recharge the batteries when you get to the 3rd Yellow LED, this is a safety precaution to avoid dead batteries